深井软岩巷道温压耦合作用下锚固体破坏机理及应用研究

doi:10.11799/ce202207010

摘要/Abstract

摘要： 针对深井软岩巷道高地温高地压锚固支护失锚率增大的问题，以淮南矿区深井软岩巷道为例，采用室内相似模拟试验方法，进行温压耦合作用下锚固体变形破坏特性和锚杆受力特征试验研究。结果表明：随着温度升高和侧压系数的增大，锚固体的破裂深度增大，而侧压系数增大则锚固体的破裂倾角减小。当λ=1.2、1.5和1.8时锚固体的破裂深度分别为托盘直径的1.02～1.2倍、1.13～2.2倍和1.15～2.4倍，锚固体破裂倾角分别为45°～60°、40°～45°和30°～35°|温度升高和侧压系数增大，锚固体压密阶段水平变形量增大，随着侧压系数的增大，温度对锚固体变形破坏规律影响减弱|锚杆在破碎块体作用下处在压、张、剪的复杂应力状态，锚杆以受张拉应力为主，弯曲位置受压、剪应力作用，随着温度和侧压系数的增大，锚杆弯曲位置受压、剪应力增大，锚杆发生明显弯曲变形，锚杆锚固体呈渐进式破坏。将全长锚固支护工艺应用于丁集矿西三轨道大巷围岩支护参数优化设计，并进行现场监测，反馈表明巷道围岩支护效果较好。

关键词: 深井巷道, 温压耦合, 模型试验, 全长锚固体, 破坏机理

Abstract: Abstract: Aiming at the problem of increasing anchor failure rate of high ground temperature and high ground pressure anchorage support in deep soft rock roadway, taking deep soft rock roadway in Huainan mining area as an example, the indoor similar simulation test method was used to study the deformation and failure characteristics of anchor solid and the stress characteristics of anchor under the coupling effect of temperature and pressure. The results show that with the increase of temperature and lateral pressure coefficient, the fracture depth of anchorage body increases, while the increase of lateral pressure coefficient decreases the fracture angle of anchorage body. When λ = 1.2, 1.5 and 1.8, the fracture depth of the anchorage body is 1.02～1.2, 1.13～2.2 and 1.15～2.4 times of the tray diameter, and the fracture dip angles of the anchorage body are 45°～60°, 40°～45° and 30°～35°, respectively. With the increase of temperature and lateral pressure coefficient, the horizontal deformation of the anchorage increases in the compaction stage. With the increase of lateral pressure coefficient, the influence of temperature on the deformation and failure of the anchorage is weakened. The bolt is in the complex stress state of compression, tension and shear under the action of broken blocks. The bolt is mainly subjected to tension stress, and the bending position is compressed and shear stress. With the increase of temperature and lateral pressure coefficient, the bending position of the bolt is compressed and the shear stress increases, and the bolt has obvious bending deformation. Bolt anchor solid progressive failure. The full-length anchoring support technology is applied to the optimization design of the surrounding rock support parameters of the main roadway of the Western Third Railway, and the field monitoring is carried out. The feedback shows that the surrounding rock support effect of the roadway is good.

中图分类号:

TD353

王佳奇, 姚直书, 刘小虎, 王晨, 乔帅星. 深井软岩巷道温压耦合作用下锚固体破坏机理及应用研究[J]. 煤炭工程, 2022, 54(7): 50-55.

参考文献

[1] Yang SQ, Chen M, Jing HW, et al.A case study on large deformation failure mechanism of deep soft rock roadway in Xin'An coal mine, China[J].Engineering Geology, 2017: 89-101.
[2] 康红普, 林健, 吴拥政, 等.锚杆构件力学性能及匹配性[J]. 煤炭学报, 2015, 40(1): 11-23.
[3] 单仁亮, 彭杨皓, 孔祥松, 等.国内外煤巷支护技术研究进展[J]. 岩石力学与工程学报, 2019, 38(12): 2377-2403.
[4] 康红普.我国煤矿巷道围岩控制技术发展70年及展望[J]. 岩石力学与工程学报, 2021, 40(1): 1-30.
[5] Sui Q, He M, He P, et al. State of the Art Review of the Large Deformation Rock Bolts[J]. Underground Space, 2021
[6] Cao J, Zhang N, Wang S, et al.Physical Model Test Study on Support of Super Pre-stressed Anchor in the Mining Engineering[J].Engineering Failure Analysis, 2020, 118:104833.
[7] 冯晓巍. 全长锚固系统失效机制及耐久性探究[D].中国矿业大学, 2017.
[8] 孟波, 靖洪文, 杨旭旭, 等.破裂围岩锚固体变形破坏特征试验研究[J].岩石力学与工程学报, 2013, 32(12): 2497-2505.
[9] 朱文心, 靖洪文, 张力, 等.锚杆作用下块状岩体力学特性试验研究[J].采矿与安全工程学报, 2018, 35(2): 261-266, 290.
[10] 王其洲, 叶海旺, 谢文兵, 等.峰后锚固体力学特性及其再破坏特征试验研究[J].采矿与安全工程学报, 2018, 35(6): 1115-1121.
[11] 韦四江, 勾攀峰.巷道围岩锚固体变形破坏特征的试验研究[J].采矿与安全工程学报, 2013, 30(2):199-204.
[12] 胡滨, 康红普, 林健, 等.温度对树脂锚杆锚固性能影响研究[J].采矿与安全工程学报, 2012, 29(5): 644-649.
[13] 苏学贵, 杜献杰, 苏蕾, 等. 高温下树脂锚固材料细观结构与力学性能实验分析[J]. 煤炭学报, 2015, 40(10): 2408-2413.
[14] Lahouar M A, Caron J, Pinoteau N, et al. Mechanical Behavior of Adhesive Anchors Under High Temperature Exposure: experimental Investigation[J]. International Journal of Adhesion and Adhesives, 2017, 78:200-211.
[15] 丁书学, 靖洪文, 齐燕军, 等.含软弱夹层锚固体变形过程中锚杆受力分析[J].采矿与安全工程学报, 2017, 34(6):1094-1102.
[16] Jing H W, Yang S Q, Chen K F. An Experimental Study on Anchorage Strength and Deformation Behavior of Large-scale Jointed Rock Mass[J].Tunnelling and Underground Space Technology, 2014, 43(43): 0-184.
[17] 顾大钊.相似材料和相似模型[M].徐州: 中国矿业大学出版社, 1995.
[18] Liu XH, Yao ZS, Xue WP, et al.Effect of Temperature and Accelerator on Gel Time and Compressive Strength of Resin Anchoring Agent[J].Advances in Polymer Technology，2019，3546153.
[19] Liu XH, Yao ZS, Xue WP, et al.Experimental Study of the Failure Mechanism of the Anchorage Interface under Different Surrounding Rock Strengths and Ambient Temperatures[J]. Advances in Civil Engineering, 2021, 6622418.
[20] Liu XH, Yao ZS, Xue WP, et al.Development, Performance, and Microscopic Analysis of New Anchorage Agent with Heat Resistance, High Strength, and[J].Advances in Materials Science and Engineering，2019，4239486.
[21] 刘石, 许金余, 刘志群, 等. 温度对岩石强度及损伤特性的影响研究[J]. 采矿与安全工程学报, 2013, 30(4): 583-588.