煤炭工程 ›› 2025, Vol. 57 ›› Issue (5): 117-124.doi: 10. 11799/ ce202505016

• 研究探讨 • 上一篇    下一篇

远距离下保护层开采覆岩裂隙演化规律及相似模拟分析

高忠国, 杨俊鹏, 辛亚军,等   

  1. 1. 黔西金坡煤业有限公司
    2. 河南理工大学
    3. 黔西金坡煤业有限责任公司
  • 收稿日期:2024-03-07 修回日期:2024-08-09 出版日期:2025-05-13 发布日期:2025-07-03
  • 通讯作者: 高忠国 E-mail:1006213718@qq.com

Fracture evolution law and similarity simulation analysis of overburden movement in long-distance lower protective layer mining

  • Received:2024-03-07 Revised:2024-08-09 Online:2025-05-13 Published:2025-07-03
  • Contact: GAO zhongguo E-mail:1006213718@qq.com

摘要:

远距离保护层开采因距离较远、卸压程度小及穿层钻孔施工难而受到制约,以黔金煤矿9#煤层(突出)与15#煤层(无突出)远距离保护层开采为背景,采用理论分析、相似模拟与现场试验开展研究,分析了远距离保护层开采后的顶板两带分布特征与瓦斯流动规律,探讨了工作面开采顶板覆岩运动与应力分布规律,设计了远距离保护层开采方案。结果表明:远距离保护层开采被保护层卸压情况主要与两带高度发育相关,工程矿井被保护层落在弯曲下沉带内;下保护层开采后,保护层上方三带产生,开切眼与终采线两侧曲线形态差别明显,煤层顶板下沉最为明显,被保护层顶板附近下沉较为缓和,上侧下沉较为明显;保护层工作面前方支承压力随工作面推进整体呈先升高再降低最后缓慢升高趋势;被保护层应力随着工作面推进,整体呈先缓慢升高后降低最后缓慢升高趋势;保护层开采过程中周期来压现象明显,平均周期来压垮落步距17m,工作面推进243m所形成裂隙发育带呈梯形,上垮落角为69°,下垮落角为62°;从15#煤施工穿层钻孔能够抽放9#煤瓦斯,钻孔抽采浓度随着时间增长呈轻微下降趋势,监测周期65d瓦斯浓度下降至3. 8%,抽采效果显著。

关键词:

保护层开采 , 煤层变形 , 裂隙发育 , 卸压范围 , 相似模拟

Abstract: Long-distance protective layer mining is restricted by the long distance, the small pressure relief and the construction difficulty of through-layer drilling, so it will be beneficial for long-distance protective layer mining to study overburden movement law and pressure relief range. Take 9# coal seam (outburst) and 15# coal seam (non-outburst) as mining background, this paper adopted theoretical analysis, similar simulation and field test to analyze the characteristics of "two zones" distribution in roof and gas flow law after long-distance protective layer mining, to discuss roof movement of working face and stress distribution law, and designed the mining scheme of long-distance protective layer. The results showed that the pressure relief of protected layer was mainly related to the height development of the "two zones", and the protected layer was in the bending subsidence zone in engineering mine; after the mining of the lower protective layer, “three zones” appeared above the protective layer, the difference between the curves of both sides of cut hole and stop-mining line were obvious, the subsidence of coal roof was the most obvious, the one near the protected layer roof more moderate, and the one on the upper more obvious; the abutment pressure in front of the working face of the protective layer increased firstly, then decreased and finally increased slowly with working face advancing; the stress of the protected layer increased slowly firstly, then decreased and finally increased slowly with working face advancing; during the mining of the protective layer, the periodic weighting was obvious, and the average collapse step of periodic weighting was 17 m, the fracture development zone formed to trapezoid as working face advance 243 m, the upper caving Angle is 69°, and the lower caving Angle 62°; 9# coal gas could be extracted from the 15# through-bed drilling, the gas extraction concentration had a slight decline trend with the increase of time, the gas concentration dropped to 3.8% in day 65, and the extraction effect was significant.