煤炭工程 ›› 2013, Vol. 45 ›› Issue (10): 122-124.doi: 10.11799/ce201310040

• 装备技术 • 上一篇    下一篇

输出本质安全型准Z源Buck变换器的设计

程红1,高巧梅2,马睿3,巩英才3   

  1. 1. 中国矿业大学(北京)机电与信息工程学院
    2.
    3. 中国矿业大学(北京)
  • 收稿日期:2013-05-28 修回日期:2013-07-03 出版日期:2013-10-10 发布日期:2013-10-24
  • 通讯作者: 程红 E-mail:chengh@cumtb.edu.cn

The design of the Output Intrinsic Safety Quasi-Z-Source Buck Converter

  • Received:2013-05-28 Revised:2013-07-03 Online:2013-10-10 Published:2013-10-24

摘要:

针对一种新型的输出本质安全型准Z源Buck变换器拓扑,推导了电流峰值控制小信号3阶模型,由于当准Z源网络参数L1、C1远小于常规变换器滤波网络参数LC时,对其实行降阶,可得到准Z源Buck变换器与常规Buck变换器相同的传递函数模型,因此可以按常规Buck变换器控制器设计方法完成准Z源Buck变换器控制器设计。论文最后采用常用的截止型输出保护电路验证了理论分析的正确性。

关键词: 本质安全, 准Z源, Buck变换器, 电流峰值, 小信号模型

Abstract:

According to a new type of the output intrinsically safety Quasi-Z-source(QZS) Buck converter , a 3-order current peak control of small signal model was deduced, because when the QZS network parameters L1, C1 is much smaller than conventional Buck converter LC filter network parameters, it can institute order reduction to the model ,then, the QZS Buck converter can obtain the same transfer function model of conventional Buck converter , so the conventional Buck converter compensator design method can be used directly to design the controller of the QZS Buck Converter. Finally, the paper used the commonly output protection circuit to verify the correctness of the theoretical analysis.

Key words: intrinsic safety, quasi-Z-source, Buck converter, peak current, small signal model.